Silicon Showcase⁠™

Your shortlist

Nothing saved yet.

Save a solution from IP Finder, a solution listing, a solution page, or a provider’s solutions to compare it here.

Saved in this browser. Information is based on published sources. Confirm suitability and configuration with the provider.

Public source

Canova Tech USB and Power Delivery IP

The USB and Power Delivery page reviewed on 12 November 2026 covers three application areas.

View Official Source (opens in a new tab)Find IP for your application

Overview

Canova Tech USB and Power Delivery IP is a family of licensable USB2/eUSB/USB-PD mixed-signal IP.

USB2 Device: CT25201 USB 2.0 transceiver for low/full-speed with built-in termination and UTMI digital interface; CT20101 48 MHz oscillator; CT25100 Billboard Device controller without MCU. Embedded USB Repeater: CT20603 dual-role eUSB2 repeater enabling eUSB2 PHY SoCs to connect to USB2.0 hosts/peripherals in Host, Peripheral, or Dual Role Repeater modes while preserving eUSB2/USB2.0 timings. USB Power Delivery: CT20601 complete USB Type-C interface with VCONN/VBUS management, dual-role ports, and dead-battery operation; CT20602 USB Power Delivery 3.1 Physical Layer with Fast Role Swap and noise management for Type-C Port Controllers and USB-PD PMICs. Address Piazza Mario Saggin, 2 - 35131 Padova, Italy is listed. Official page names discrete licensable IP part numbers.

Technical capabilities

  • Published as design IP

    Licensable semiconductor IP. This listing is not a finished controller chip.

  • PHY IP

    Physical-layer IP. Controllers are separate listings unless the page states a bundle.

  • Finder function

    USB2/eUSB2/USB-PD

  • Numbered specification: USB 2.0 FS/LS

    USB 2.0 FS/LS is named for this product on the reviewed page.

  • Numbered specification: eUSB2

    eUSB2 is named for this product on the reviewed page.

  • Numbered specification: USB Power Delivery 3.1 (CT20602)

    USB Power Delivery 3.1 (CT20602) is named for this product on the reviewed page.

Lifecycle and categories

Solution categories
USB IP
Supported versions
USB 2.0 FS/LS; eUSB2; USB Power Delivery 3.1 (CT20602)
Compatibility
UTMI digital interface on CT25201; Type-C/PD host-controller pairing for CT20602. Source

Related solutions

Cadence USB 3.0 xHCI Host Controller IP

USB IP

Cadence USB 3.0 xHCI Host Controller IP is a USB host controller. The brochure states SuperSpeed at 5 Gbps, High-Speed at 480 Mbps, Full-Speed at 12 Mbps, and Low-Speed at 1.5 Mbps, with a separate PHY. It does not state a faster SuperSpeed host rate, USB Type-C, or USB Power Delivery. A device-only USB controller is a different role.

View solution

Corigine USB 3.2 Controller IP

USB IP

Corigine USB 3.2 Controller IP is licensable USB controller IP for ASIC and FPGA. The official USB IP page states USB-IF certified controllers for USB 3.2 Gen1/Gen2 and USB 2.0 with Host, Device, and DRD configurations.

View solution

Design Gateway USB 3.0 Host/Device IP Core

USB IP

Design Gateway USB3.0-IP is licensable USB 3.0 host or device controller soft IP for AMD FPGAs. The official page states USB 3.0 Revision 1.0 compliance for link and protocol layers with PIPE PHY interface.

View solution

Faststream AXI USB 2.0 Device IP (Semiconductor IP Catalogue)

USB IP

Faststream Semiconductor IP includes a licensable AXI USB 2.0 Device IP core within a broader catalogue. The official Semiconductor IP page lists USB, PTP, AXI-oriented, DSP, SERDES and related cores with licence/delivery process.

View solution

Soft Mixed Signal USB 2.0 PHY IP

USB IP

Soft Mixed Signal USB 2.0 PHY is licensable PHY transceiver IP. The official product page states a fully integrated Host/Device/OTG transceiver compliant with USB 2.0 and UTMI/UTMI+ interfaces.

View solution

Synopsys USB 3.2 Device Controller IP

USB IP

Licensable design IP. USB 3.2 controller with documented device support. Host and dual-role support are not documented.

View solution

Related events

Explore promotion options